Care And Maintenance - Sanyo SC-N525T Instruction Manual

CARE OF TURBO CLEAN /
Before caring for the TURBO CLEAN , be sure to turn OFF the switch of the unit and disconnect
the plug from the outlet.
If needles, pins or waste paper get stuck in the suction inlet, remove them after going through
the above procedure.
Trying to remove them during operation is dangerous.
EDGE GRABBER
The Edge Grabber system is designed to help
clean all the way up to the baseboards. The
suction shutter is opened when the floor
nozzle is pushed against the wall.

CARE AND MAINTENANCE

If you have a problem with your vacuum cleaner, consult the handy guide below. If the vacuum
cleaner is malfunctioning, do not operate it. Contact your dealer or the nearest Sanyo Service Center.
Problem
(1)Cleaner won't run.
(3)Cord doesn't fully rewind.
TM
TM
TM
/
Possible cause
1. Not firmly plugged in.
2. No voltage in wall outlet.
2. Clogged floor nozzle or
hose.
1. Cord twisted or uneven.
Edge grabber
Possible solution
1. Plug unit in firmly.
2. Check fuse or breaker.
1. Clean out the filter.
2. Clean out floor nozzle or
hose.
1. Pull out cord and rewind.