Engine Access; Exterior Sealants; Generator Filters; Trailer Hitch Connector Wiring - Fleetwood 2003 Southwind User Manual

sions. Therefore, keep the floor clean and use
exterior walk off mats at the entry door, and:
• Immediately blot up spills or spots with a
damp cloth.
• Periodically clean the floor with Anderson
Quick Kleen. Follow the instructions on the
container.
Your wood floor can be damaged by a number
of things, including:
• Water - Do not wet mop the wood floor
• Oil soap or other waxes and polishes
• Ammonia cleaners
• High heel shoes
Engine Access
The top of the engine may be accessed from
inside the motor home for service by lifting or
removing the engine cover.
WARNING
The interior engine
cover
is
heavy.
Use care when
opening or closing the cover.
WARNING
When installing the engine cover, be sure the cover is
fully seated on the gasket seal and secured by the
clamps. Do not allow insulation, carpeting, or other
material to interrupt the seal between the
cover
and
the engine compartment.
If
the engine cover is not
installed correctly, engine exhaust gases could leak
into the passenger compartment creating a safety
hazard. If the engine must be run with the engine
cover
off for maintenance purposes, be sure the vehi-
cle interior is adequately ventilated.
EXTERIOR SEALANTS
Consult your Fleetwood Motor Home dealer for
the most current sealant use.
Windshield
Window sealant
Roof sealant
Maintenance
GENERATOR FILTERS
Consult your Fleetwood Motor Home dealer or
see the Onan Service and Parts Directory in
your Owner's Information Package.
Oil Filter
Fuel Pump Filter
Element Fuel Filter
TRAILER HITCH
CONNECTOR WIRING
Trailer Hitch Electrical Connector
(View is looking at the connector on the RV from
the wire harness end. Plug must be removed
from housing to
view
legend.)
4
Terminal
No.
1
2
3
4
5
6
7
3
2
5
Circuit
Connection
Ground
7
Electric Brake'
Tail/Clearance
Spare or Battery Charge
Left Turn and/or Stop
Right Turn and/or Stop
Spare or Stop
'This circuit is provided to allow the use of a con-
troller for electric brake actuation of a towed trailer
or vehicle.
"' I
NOTE
1
Due to manufacturing differences between products,
wire color coding may be different than terminal
colors indicated.
11-5
I~