Advertisement
SAFETY WARNING
• Persons without excellent vision, balance, coordination, reflex, muscle and
bone strength or good decision-making capability should not use this
product.
• This product should not be used by minors without adult supervision.
• This product should not be used by persons unwilling to take responsibility
for their actions.
• The user of this product assumes all risks, all users must wear safety
helmet, goggles, gloves, elbow and kneepads, ankle support, and
appropriate shoes.
OVERHEATING
Your electric Go-Ped® is equipped with an automatic thermal cutoff
switch. When the vehicle is abused by running continuously over
excessive grades (inclines), over soft materials like carpet, or rubber
mats, or exceeding the recommended total weight capacity of 250 lbs.,
the motor will get overheated. The internal thermal switch will disconnect
the power from the motor until the temperature has once again reached
safe levels. The Go-Key® will have to be removed and re-inserted to reset
the electronic controllers. Operating the controls (pulling the throttle and
brake levers) continuously while standing still will also cause internal
damage.
TIRES
Non-pneumatic tires require no maintenance, but must be replaced when
normal wear and tear makes the tire diameter reach the wear limit
("dimple") found on the side of the tire. Inspect for damage (i.e. split,
cracked or torn tires should be replaced immediately)
Accessories
GETTING STARTED
Inspect your Go-Ped® for shipping damage, and to ensure all components are in
proper order. In the case of any damage or questions, contact your authorized Go-
Ped® reseller or call the Go-Ped® technical support line at (925) 373-7827. Office
hours are Monday-Friday 8:00 a.m. – 5:00 p.m. PST
BATTERY CHARGING
The Electric Go-Ped® comes partially charged. It is highly recommended that you
charge your Electric Go-Ped® for a minimum of 3 hours
before your initial use.
The LED
It is used to help provide battery status at times of use or
while being charged. All five illuminated LED lights indicate
a full charge while one indicates a dead battery.
The provided power cord (or a standard computer power
cord) and a wall socket is all that is needed to charge your
Go-Ped®. Plug one end of the power cord into the right/rear
of the standing platform
Always remember to unplug your Go-Key®
use.
The batteries used to power your Go-Ped® are Sealed
Lead-Acid. These are very similar to the technology used in
maintenance-free auto batteries. Lead-Acid batteries
.
NOT
discharge your batteries to the point that your Go-Ped® is barely moving. Do not
exceed 12 hours of charging time. Over-discharging and/or over-charging Lead-
Acid batteries will greatly diminish the battery cycle life. You should also try and
"Top Off" your batteries (3 to 4 hours) before setting out on a long ride. We also
recommend that you
an extended duration and up 5% grades or greater.
Minimum charge time
Best charge time
Maximum charge time
DO NOT EXCEED
life.
SAFETY WARNING
Internal electrical and electronic parts can cause severe electric shock, and
should not be accessed by anyone other than factory-authorized personnel.
A1
display on the deck is called the Flux Capacitor.
A4
and the other into the wall socket.
retain any memory, meaning you should NEVER fully
DO NOT
attempt to ride the Go-Ped® uphill at full-throttle for
the 12-hour max. Charge time to optimize your battery cycle
A2
when not in
DO
3 hours
4 to 6 hours
12 hours
Advertisement
