Advertisement
Pay EXTRA ATTENTION to the yellow, SAFETY WARNING sections of this
manual. These are very important to understand before you ride your Go-
BE SURE TO READ THESE INSTRUCTIONS CAREFULLY
Ped®.
BEFORE ATTEMPTING TO START OR OPERATE THIS UNIT.
HOVERBOARD / STEALTH GO-PED®s SPECIFICATIONS
* Speeds and Running Durations vary significantly depending on the weight of
the rider and conditions of road surface, grade and weather.
IMPORTANT! If you did not completely fill out and submit a warranty
registration form to your dealer upon purchasing your Go-Ped® product,
return to your dealer immediately and do so. If your form is not turned into
the manufacturer, YOU DO NOT HAVE A WARRANTY.
FREQUENTLY ASKED QUESTIONS / TROUBLESHOOTING
Question: How far does my Electric Go-Ped go?
•
Approximately 7-12 miles. This depends on rider weight & riding
conditions i.e. smooth/ rough surface, wind & grade (hills).
Question: How long does my Electric Go-Ped take to charge?
•
3 to 4 hours
Question: Is it legal to ride on public roads or sidewalks?
Please consult your local Law Enforcement Agencies.
•
Question: Is there a seat for the Hoverboard / Stealth?
•
Yes, the Sat Squatch Seat which work on all Go Ped models. Visit
www.Goped.com
for more information
Question: What is the maximum weight capacity of the Hoverboard /
Stealth?
250 pounds; to prevent overheating of the motor.
•
Question: Is it okay to completly discharge the batteries?
•
No, these Lead-Acid Batteries do not retain memory & should be topped
off before every ride. Fully discharging them will render them useless.
Question: How many times can I charge my Electric Go-Ped?
The Sealed Lead Acid Batteries have a life-cycle of approximately 300
•
charges.
Question: My Go-Key® doesn't light up! What could be wrong?
*The battery connections might have become loose.
•
•
*Fuse on the control board might been damaged.
Question: Key is luminated, but Go-Ped doesn't work.
•
Remove the Go-Key for a minimum of 30 seconds then place back in.
•
Check front brake lever. A partially engaged brake or improper alignment
of the brake sensor will engage the engine brake system.
Question: Diminished range, will not hold a charge?
The batteries have been over-discharged or not charged enough. One or
•
more batteries may need to be replaced.
•
Battery abuse, such as too heavy of a load and too steep of a incline will
cause premature Battery failure.
*Battery connection might have become loose.
•
*Battery voltage should be in the range of 6.2 volt to 6.7 volt.
•
•
*Batteries should be Load Tested to ensure full Amperage (3amp)
Question: Why does my Go-Key dim when I engage throttle?
•
Dead Battery(ies)
•
*Remove deck and check Battery wires for loose connections.
Question: Charger light does not come on?
•
*Check the 3.15 amp glass fuse on the Charger Board.
•
*Check (3) spade connectors on A/C Socket Plug.
Question: Motor overheats and shuts off?
•
Exceeding Maximum weight.
•
Too steep of incline (grade).
•
Pumping the throttle lever with Go-Key inserted
•
Remove the Go-Key for a minimum of 30 seconds then place back in.
•
Too much Motor spring pressure.
Question: I need to buy parts for my Go-Ped, where should I go?
•
To find your nearest Go-Ped® Dealer, please go to www.Goped.com and
click on "find-a-dealer". An alternative would be the Go-Shop section
located on Goped.com
*Work must be done by a Go-Ped technician for repairs. Performing any of the
procedures will void your warranty. Goto
dealer for technical help.
www.Goped.com
to find you nearest local
Advertisement
