Download Print this page

Removing A Power Supply - Dell PowerConnect B-DCX-4S Backbone Replacement Procedure

Power supply and filler panel
Hide thumbs Also See for PowerConnect B-DCX-4S Backbone:

Advertisement

Figure 2
shows the location and identification of the power supplies for the PowerConnect B-DCX-4S.
1
Power supply 1 (PS1)
FIGURE 2
Power supply identification for the PowerConnect B-DCX-4S

Removing a power supply

1. Perform one of the two following tasks:
For the PowerConnect B-DCX:
If the PowerConnect B-DCX is not operating during the replacement procedure, go to step 2.
If the PowerConnect B-DCX is operating and will continue to operate during the replacement, check the
power LEDs to verify that the minimum number of power supplies is functioning. A fully populated
PowerConnect B-DCX requires a minimum of one power supply at all times.
For the PowerConnect B-DCX-4S:
If the PowerConnect B-DCX-4S is not operating during the replacement procedure, go to step 2.
If the PowerConnect B-DCX-4S is operating and will continue to operate during the replacement, check the
power LEDs to verify that the minimum number of power supplies is functioning. A fully populated
PowerConnect B-DCX-4S requires a minimum of one power supply at all times.
2. Turn off the power switch.
3. Remove the power cord.
4. Loosen the thumb screw on the right side of the power supply.
4
2
Power supply 2 (PS2))
Power Supply and Filler Panel Replacement Procedure
53-1001794-01

Advertisement

loading

This manual is also suitable for:

Powerconnect b-dcx backbone