IDTECK Star 100W User Manual page 18

12-45. Enable Toggle Mode for Lock Control
Configuration Card
/Configuration PIN
12-46. Disable Toggle Mode for Lock Control
Configuration Card
/Configuration PIN
12-47. Enable Lock followed by Door Contact
Configuration Card
/Configuration PIN
12-48. Disable Lock followed by Door Contact
Configuration Card / Configuration PIN
12-51. Disable Melody Sound
Configuration Card
/Configuration PIN
12-52. Enable Melody Sound
Configuration Card
/Configuration PIN
12-60. Change Keypad Lock-out Time When Try-Out Error Detected
mm
(
=00~99 min., Default Keypad Lock-out time= 01 min.
Configuration Card Command
/Configuration PIN
12-61. Set AUX Input #1 Detection from 'L' to 'H'
AUX#1 input is detected on the rising edge of AUX#1 input
Configuration Card / Configuration PIN
12-62. Set AUX Input #1 Detection from 'H' to 'L'
AUX#1 input is detected on the falling edge of AUX#1 input
Configuration Card / Configuration PIN
If you enable the Toggle Mode, the door will be toggled open/closed when a
registered card or PIN is entered. You may use this function for Arm/Disarm for
burglary alarm system.
If you enable "Lock followed by Door Contact", the door will only be locked
followed by Door Contact so the door will remain unlocked until the door is
completely closed.
(Default setting=Enable)
Keypad Lock-out time
(Default setting)
18
)