Pride Legend Owner's Manual page 28

V I I I . D I S A S S E M B L Y A N D A S S E M B L Y
ASSEMBLY
1. Pull up on the manual freewheel lever. See IV. “Description.” Placing your Scooter in freewheel mode may
make it easier for you to maneuver the rear section because the drive wheels are free to turn.
2. Position the front and rear sections of your Scooter as shown in figure 25.
3. Tilt the rear section to a horizontal position and insert the longer tube of the front end into the rear section first.
Make sure that the camlock levers are in the unlocked (vertical) position and the ball detent pins are removed.
4. Slide the two sections of the unit together until the front half reaches its insertion limit.
5. Secure the front and rear sections with the ball detent pins.
6. Push the camlock levers back to their locked (downward) position.
7. Plug the front-to-rear connector (located on the front section harness ) to the connector mating socket (found
on the rear electronics module).
8. Place the batteries in the battery wells, then reconnect the battery tie-down straps (if so equipped).
9. Connect the 2-pin battery harnesses into the mating harnesses that extend from the rear electronics module.
10. Gently place the rear shroud over the seat pedestal and slide it down into position. The Velcro fasteners hold
it in place.
11. Carefully lift the seat and slide the seat post (on the bottom of the seat frame) into the seat post tower.
12. Rotate the seat until it locks into place to complete assembly of your Scooter.
28 Legend