Pride Legend Owner's Manual page 32

X . C A R E
MOTOR BRUSHES
n Have your authorized Pride provider periodically inspect the motor brushes for signs of wear. The brushes are
housed inside of the motor transaxle assembly.
CONTROL CONSOLE MODULE, ELECTRONICS MODULE, AND ONBOARD BAT-
TERY CHARGER
n Keep these areas away from moisture.
n If any of these areas have been exposed to moisture, let them dry thoroughly before operating your Scooter.
REAR LIGHTS
The 24V 5W bulbs used to illuminate your Scooter’s rear lights can be purchased through your authorized Pride
provider. You can replace these bulbs easily.
1. Use a Phillips head screwdriver to loosen the screw on the light cover; then remove the light cover.
2. Gently remove the bulb from between the clip.
3. Insert the new bulb.
4. Replace the light cover; then tighten the screw.
FUSES
You can purchase the fuses used in your Scooter at any automotive parts store. You can replace the fuses easily.
1. Remove the fuse by pulling it up and out of its slot.
2. Examine the fuse to be sure it is blown. See figure 12.
3. Insert a new fuse with the correct rating.
WARNING! The replacement fuses must match the rating of the original fuses exactly. If
you install a fuse with an incorrect rating, you may damage the electrical system and pose
a potential fire risk.
Storage
For prolonged storage, you may wish to place several boards under the frame of your Scooter to raise it off the
ground and take the weight off the tyres. This reduces the possibility of flat spots developing on the areas of the
tyres contacting the ground.
.
32
A N D M A I N T E N A N C E
Legend