Sony DNW-A75 BETACAM SX Operation Manual page 90

7-3 Extended Menu
Item number Item name
107 REC INHIBIT LAMP
FLASHING
108 AUTO EE SELECT
109 FORCED EE WHEN
TAPE UNTHREAD
111 TSO/FEED PLAY
115 PHASE LOCK IN
VARIABLE X3
116 JOG DIAL RESPONSE
117 CONTROL PANEL
SELCTION
a)
Speed
TYPE 2
FWD
+3
(reverse)
+1 Rotation rate
RVS
FWD
-1
-3
RVS
7-10
Chapter 7 Menu System
Menu items in the 100s, relating to the control panels (Continued)
Settings
Select whether or not to flash the REC INHIBIT indicator when the REC INHIBIT
switch on the subsidiary control panel is set to OFF and the REC inhibit plug on
the cassette is pressed in.
OFF : Do not flash the REC INHIBIT indicator.
ON: Flash the REC INHIBIT indicator.
When a digital cassette is inserted and the PB and PB.EE buttons on the lower
control panel are set to the PB/EE mode, select the VTR modes in which input
video and audio signals are automatically handled in EE mode.
When an analog cassette is inserted, regardless of the menu setting the PB mode
is always selected.
S/F/R : In STOP/EJECT/F.FWD/REW modes
STOP: In STOP/EJECT modes
During tape threading and unthreading, and when no cassette is inserted, select
whether the PB and PB.EE buttons on the lower control panel control the output
signal PB/EE setting.
ON : No control by the PB and PB.EE buttons (the signal is always an EE signal).
OFF: Control by the PB and PB.EE buttons.
Select whether to enable tape speed override mode or feed play mode.
DIS : Disable both tape speed override mode and feed play mode.
TSO: Enable tape speed override mode.
FEED: Enable feed play mode.
Select whether or not to lock the capstan phase in X3 variable speed play mode.
OFF : Do not lock.
ON: Lock.
Select the tape speed characteristics for the jog dial rotation rate (VTR
commands).
TYPE1 : Tape speed varies linearly over the range –1 to +1.
TYPE2: Tape speed varies stepwise as shown in the figure below
range –3 to +3. (Characterized by a zone around –1 and +1 where the tape
speed is independent of the rotation rate)
TYPE3: Tape speed varies linearly over the range –3 to +3, as shown in the
b)
figure below
TYPE4: Tape speed varies stepwise as shown in the figure below
range –2 to +2. (Characterized by a zone around –1 and +1 where the tape
speed is independent of the rotation rate)
Select the control panel function when the CONTROL PANEL switch on the
subsidiary control panel is set to EXT.
SW : Only the control panel connected to the external control connector on the
connector panel functions.
PARA : Both the control panel connected to the external control connector and
the control panel of this unit function.
b)
Speed
TYPE 3
FWD
+3
RVS FWD
-3
RVS
.
c)
Speed
TYPE 4
FWD
+2
+1
Rotation rate
RVS
-1
-2
RVS
a) over the
c) over the
(Continued)
Rotation rate
FWD