Sony SRW-5000 Operation Manual page 160

Item number Item
302 PREROLL TIME
303 POSTROLL TIME
304 VAR SPEED RANGE
FOR
SYNCHRONIZATION
305 EDIT FIELD select
306 SYNCHRONIZE
160
Menu List
Setting Function
0 sec This sets the preroll time. The range is from 0 to 30
seconds, in steps of 1 second. The preroll time should
generally be set to at least 3 seconds, and for phase
[5 sec]
adjustment with an editing controller it is recommended to
set the preroll time to at least 5 seconds.
30 sec
0 sec This sets the tape running time after passing the OUT point
(postroll time) in automatic editing.
The range is from 0 to 30 seconds, in steps of 1 second.
[5 sec]
30 sec
[-1 to +2]
Specifies the variable tape speed range when the variable
–1.15 to +2.45 speed playback is executed by a remote control unit
connected to the REMOTE 1-IN(9P) connector.
–1 to +2: –1 to +2 times normal tape speed
–1.15 to +2.45: –1.15 to +2.45 times normal tape speed
Note
When an editing control unit such as BVE-9100 is
connected for DT editing, select "–1.15 to +2.45".
[1F]
Selects the start timing for editing when performing tape
2F editing.
1F/2F 1F: Start editing from field 1 and end on field 2.
2F: Start editing from field 2 and end on field 1.
1F/2F: Following received timing commands.
Note
When the system frequency of this unit is PsF mode, the
unit always operates with the 1F setting.
[accurate]
When this unit is used as a controller for editing control of
rough another VTR connected through a 9-pin remote cable, this
off selects whether or not to carry out phase synchronization
of the two VTRs, and also the editing accuracy when
carrying out synchronization.
accurate: Editing is carried out with an accuracy of ±0
rough: Editing is carried out with an accuracy of ±1 frame.
off: Synchronization is not carried out.
frames.