Programming; Menu Command; Changing Individual Functions; Programmable Functions - Ariston MCA15NAP Instructions For Use Manual

Programming

Setting machine functions
NA
The user can change a number of the machine's
operating parameters according to personal preference.
These functions are:
Standby, Rinsing, Language, Contrast, Water hardness,
Temperature, Coffee Size, Quantity of Water, Steam
time, Espresso flavour, Coffee flavour, Long coffee
flavour, Pre-brewing, Counter, Timer, Clock and
Washing cycle.

MENU command

To change operating parameters, enter programming
mode with the
In programming, select the required function and press
the key. This scrolls you through the functions
available on the machine.
To exit the programming, press the

Changing individual functions

Select the required function by pressing the
Enable the required function with the
through the variables using the
required variable, press
Note: the key interrupts programming at any time
without saving changes. This operation is only possible
before pressing the
16
key, when the machine is at rest.
key.
key. Scroll
key. To save the
key.
key.

Programmable functions

STANDBY
When the appliance is used very little, it is possible
to select the STANDBY mode. This function reduces
energy costs. Nevertheless, it is recommended to
switch off the appliance at the mains if it is to be out of
service for long periods. The machine reheats in just a
few minutes when reactivated.
Select the function by pressing the
STANDBY
RINSING
and enable with the
STANDBY
The machine is on but none of its components is active.
To activate the machine press
RINSING
Immediately after heating, the appliance automatically
eliminates any water left in the internal ducts to ensure
that only fresh water is used to make coffee.
The function has been enabled by the manufacturer.
To disable the function, press the
key.
function:
RINSING
LANGUAGE
and enable it with the
RINSING
ON
key
*
key. The display shows:
.
key, select this
*
key. The display shows: