Cisco Aironet Quick Start Manual page 4

2 Connect and Power Up the Access Point (continued)
350 Series Access Points
Note The following steps apply to 350 Series access points with metal or plastic cases.
Option 1
Switch with
inline power
SYST 1
RPS 2 3
4
STAT UTIL DUPLX 5 6
SPEED 7
8 10Base-
MODE 9 10 T / 100Base -TX
11 12
13
14 15
16
17
18 19 Catalys t 2950
20 SERIES
21 22
23 100Base
24 23 -FX
24
Access Point
Adjust the access point antennas. Step 1 on page 3 of this guide provides guidelines for
Step 1
positioning the antennas.
Step 2 Consult the drawing above and choose the power supply option you will use.
Connect the Ethernet cable to the Ethernet connector on the back of the access point.
Step 3
Connect the other end of the Ethernet cable to one of the following:
• A switch with inline power, such as a Cisco Catalyst 3524-PWR-XL
An inline power switch power panel, such as a Cisco Catalyst Inline Power Patch Panel
•
The end of a Cisco Aironet power injector labeled To AP/Bridge and the end labeled To
•
Network to the 10/100 Ethernet LAN.
Caution The power injector is designed for 350 series access points only. Using the power
injector with other Ethernet devices can damage the equipment.
4
Option 2
Switch
(without inline power)
SYST 1
RPS 2
3 4
STAT UTIL 5
DUPLX SPEED 6 7
8 10Base-
MODE 9 10 T / 100Base
11 -TX
12 13
14
15 16
17
18 19 Catalys t 2950
20 SERIES
21 22
23 100Base
24 -FX
23 24
Inline Power
Patch Panel
SYST
RPS
STAT
UTIL DUPLX SPEED
MODE
Option 3
Switch
(without inline power)
SYST 1
RPS 2
3 4
STAT UTIL 5
DUPLX SPEED 6 7
8 10Base-
MODE 9 10 T / 100Base
11 -TX
12 13
14
15 16
17
18 Catalys t
19 20 2950
21 SERIES
22 23 100Base
24 -FX
23 24
Power injector
Power
cord
Universal
power supply