Rear Panel Features - Red Sound SoundBITE Manual For Use

2. BPM DISPLAY:
The four digit BPM reading of the audio input signal will be displayed here. Also, information
will be displayed in [LOOP EDIT] and [BPM EDIT] modes.
3. ERASE ALL:
This button is used to erase ALL six loops simultaneously.
4. LOOPS:
These six buttons are used to record and playback the loop samples. Each button has a pre-
determined sample length in musical 'beats' - 1, 2, 4, 8 and 16 beat loops are available.
5. SAMPLE MODE:
and plays it around continuously, HOLD mode re-starts the sample each time the button is pressed which allows
you to play short bursts of audio whilst REVERSE mode plays the sample backwards when the button is pressed.
6. HEADPHONE OUTPUT:
source so connect your headphones to this socket for normal DJ monitoring purposes.
7. RE-SAMPLE:
This button is used to over-record any pre-recorded loop samples.
8. TAP/CLEAR [BPM RANGE]:
no defined beat information available. Also, when pressed and held down, the [EDIT] jog dial selects the active
range for the BPM engine - 60 to 120, 90 to 180 and 115 to 230BPM range settings are available.
9. DISENGAGE ENGINE:

REAR PANEL FEATURES

1. LOOPS OUT:
Use the supplied cables [1 into 2 RCA] to connect SoundBITE's output to a spare input channel
on your mixing desk.
2. INPUT:
Use the supplied cable [1/4 jack to RCA] to connect the headphone monitor output from your mixing
desk to SoundBITE's audio input.
3. 9vDC POWER IN:
This switch selects the three sample modes. CYCLIC mode automatically creates the loop
SoundBITE uses the headphone output on your mixing desk for its' audio input
This button is used to clear the BPM reading and tap in a tempo if there is
This button is used to disengage and re-engage the BPM engine.
SoundBITE
AUTO - LOOP MODULE
LOOPS OUT
R
1
Only use the RED Sound PSU supplied with SoundBITE to power the unit.
Top/Front Panel Features
Red Sound
INPUT POWER
-
L R L
2
3
[ 9vDC ]
+
3
OWNERS MANUAL