Table of Contents
Advertisement
Fig. 3
G
5. Place one hole of the foot plate to the L shape end of
the U-bolt on the other hole on the end of the U-bolt with
the threading and screw on the wing nut until the foot
plate is securely in place.
6. Repeat step 5 to install the remaining foot plate.
7. Use your hand to press the four casters onto the four
axis on the two foot plates until you hear them snap into
place. Use your hand to turn the casters and if
they move smoothly they have been installed properly.
8. Turn the heater right side up - your heater is now
ready for use.
BASIC OPERATING INSTRUCTIONS
(See Fig 1 & 2)
1. Ensure the power switch (D) is set to the OFF (O)
position
2. Plug in heater
3. Flip the power switch to the ON (-) position. The power
light (I) will illuminate red until the unit is unplugged.
4. Press the mode button (L) once to activate the unit. The
mode light (J) will glow green to indicate the heater is
running. The unit will automatically start on setting 3
(high heat).
5. Press the mode button until the desired heat setting is
shown on the display panel (H).
BOF2001-CN: 1=600W, 2=900W, 3=1500W,
(EC)= Heat & $ave™ Mode
G. Front castor assembly
P. Front wing nut
Q. Castor
R. Rear castor assembly
T
S. Rear wing nut
T. U-bolt
P
Q
R
S
Hide quick links:
Advertisement
Table of Contents
