Front Tire Replacement - Razor E300 Series Owner's Manual

REPAIR AND MAINTENANCE
Reassembly
5
Install the chain onto the rear
wheel sprocket. Slip wheel axle
into the frame slots. See rear wheel
hardware sequence on prior page.
Push the chain tensioner down to
create slack in chain. Hand tighten
rear axle locknuts.
8
Thread the brake cable through the brake adjuster barrel, through
the large spring, and into the small hole in the side of the anchor bolt.
Position the cable to the original location (as indicated by the slight
cable kink) and tighten securely.
10
Replace the chain guard.

Front Tire Replacement

Tools required: Two (2) 16 mm wrenches.
6
Verify chain is properly installed
E300
on each sprocket and tensioner is
correctly positioned at the bottom
of the chain.
9
Tighten the cable guide bracket bolt.
Tighten the locknuts on the rear axle. Test
the brake to verify proper function before
riding. Readjust as needed.
1
Using two (2) 16 mm wrenches,
loosen the front axle bolts by
turning the wrenches counter
clockwise. Remove wheel and
install replacement wheel. Note
the sequence of the hardware.
Cable Guide
Bracket
Nut
Frame
Spacer
Bolt
Washer
Brake Plate
7
Install the cable guide
bracket to the frame and brake
plate using bolt, washers, and
nut. Do not tighten.
8
Note: Front wheel hardware
sequence.
9-1
9-2
9-3
9-4
9-5
9-6
9-5
9-4
9-3
9-2
9-1
Right Side (Throttle)
9-5 - Spacer
9-4 - Washer
Fork
9-3 - Washer
9-2 - Spring Washer
9-1 - 16 mm Locknut
Middle
9-6 - Front Axle Bolt
Left Side (Brake)
9-5 - Spacer
9-4 - Washer
Fork
9-3 - Washer
9-2 - Spring Washer
9-1 - 16 mm Locknut