Only For Training And Service Purposes - LG KF700 Service Manual

B. the others
❏ TRK_LO_ADJ : TCXO(19.2M) Control
❏ PA_ON : WCDMA(2100) TX Power Amp Enable
❏ ANT_SEL[0-2] : Ant Switch Module Mode Selection(WCDMA,GSM Tx/Rx,DCS-PCS Tx/Rx)
❏ GSM_PA_BAND : GSM/DCS-PCS Band Selection of Power Amp
❏ GSM_PA_RAMP : Power Amp Gain Control of APC_IC
❏ GSM_PA_EN : Power Amp Gain Control Enable of APC_IC
3.10.2 MSM Sub System
SIM Interface
SIM interface scheme is shown in Figure.
And, there control signals are followed
❏ SIM_CLK : SIM Clock
❏ SIM_Reset : SIM Reset
❏ SIM_Data : SIM Data T/Rx
UART Interface
UART signals are connected to MSM GPIO through IO connector with 115200 bps speed.
Copyright © 2008 LG Electronics. Inc. All right reserved.

Only for training and service purposes

[Fig. 3.14] SIM Interface
- 51 -
3. TECHNICAL BRIEF
LGE Internal Use Only