Desa CDR3924NT Owner's Operation And Installation Manual page 15

INSTALLATION
Continued
1. Place middle log (#1) onto log alignment
screw located near the center of base and in
place over log support bracket as shown in
Figures 17 and 18.
2. Place front log (#2) onto base. Position log
onto two alignment screws to the front of base
(see Figure 18).
3. Place left side log (#3) onto two log alignment
screws on left side of base (see Figure 18).
4. Place right side log (#4) onto two log alignment
screws on right side of base (see Figure 18).
5. Place rear log (#5) onto two alignment screws
to the rear of base (see Figures 17 and 19).
6. Place crossover log (#6) onto log alignment
pin on middle log (#1) and rear log (#5) (see
Figure 19).
Left Log
Front
Log
Middle
Log
Front Log
Figure 17 - Log Alignment Screws
Left Log #3
Figure 18 - Installing Middle Log #1, Front
Log #2, Left Log #3 and Right Log #4
113183-01F
Rear Log
Log Support
Bracket
Middle
Log #1
Front
Log #
Right
Log #4
www.desatech.com
Crossover
Log #6
Rear
Log #5
Figure 19 - Installing Rear Log #5 and
ATTACHING GRATE TO BASE
ASSEMBLY
Locate the two slots in the front of the base as-
sembly. Carefully slide the decorative grate into
these slots (see Figure 20).
Right
Log
Grate
Figure 20 - Attaching Grate to Base
ADDING LAvA ROCK
Place lava rock around base of heater if desired.
Be sure not to cover the control knobs or air inlet
openings on the front of heater.
Crossover Log #6
Slots in Base
Assembly
15