CABLE ROUTING
Left handlebar switch lead
Main switch lead
Clutch cable
Throttle cables
Right handlebar switch lead
CABLE ROUTING
Clamp the right and left handlebar switch leads
and handlebars. Point the tip of the clamp
downward in front of the handlebars.
Clamp the horn lead and main switch lead
(upper side only) to the inner tube. Point the
binding section to the outside of the vehicle
body and cut the tip down to the length of 1 to 5
mm (0.04 to 0.20 in).
Route the horn lead by the headmost side.
Pass the throttle cables, wire harness lead,
clutch cable, main switch and immobilizer lead
and left handlebar switch lead in order through
the frame hole from the inner side of the vehicle.
3
SPEC