Setup Process 2 - Black Box HS100A Manual

Figure 4-5. Replacing the Battery Lid.

4.2 Setup Process 2

If your telephone system does not
appear in Table 4-1, follow this
process. You will not be able to
achieve compatibility without
completing all the points included
in Chapter 3, How to Make a Call.
1. Remove the lid for the
battery compartment by
sliding it to the left and then
lifting it off.
Figure 4-6. Removing the Lid.
2. Make sure that the
telephone type switch is in
position C.
Figure 4-7. Adjusting the Telephone Type
Switch to Position C.
3. Take the phone off the
hook and make a call. If you
do not get a dial tone, go to
setup process 2a on the next
CHAPTER 4: Telephone Compatibility and Setup
page. If you achieve a
connection, adjust the
transmit control to either
position 1 or 10. (The
middle settings of the
transmit wheel have little
effect in telephone type C
setting. Setting 1 or 10 will
give the best results.)
Figure 4-8. Adjusting the Transmit Control.
4. To replace the battery lid,
align it at the right hand
side of the battery
compartment and press
down. Then slide it to the
right.
17