Storage; Service Parts; Accessories - Ariens Sno-Thro 932105 - 8526 , 932506 - 8526 Owner's/Operator's Manual

5. Bolt new friction disc to shift carrier.
Tighten hardware to 5-6 lbf-ft (6.8 to
8.13 N•m).
6. Install roll pins in hex shaft. Ensure roll
pins are centered in hex shaft.
7. Install shift rod on speed selector arm.
8. Install bottom cover.
9. Install wheels.
10. Set unit upright.
11. Install spark plug wire on spark plug.
12. Adjust speed selector lever (see Speed
Selector Adjustment on page 21).

STORAGE

WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SHORT TERM
IMPORTANT: NEVER spray unit with high
pressure water or store unit outdoors.
Run with attachment clutch engaged a few
minutes after each use to free unit of any loose
or melting snow.
Close fuel shut-off valve.
Inspect unit for visible signs of wear, breakage
or damage.
Keep all nuts, bolts and screws properly
tightened and know unit is in safe working
condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low
pressure water and lubricate (see
Maintenance). Touch up all scratched painted
surfaces.
Remove weight from wheels by putting blocks
under frame or axle.
When storing unit for extended periods of
time, remove all fuel from tank and carburetor
(run dry). Refer to Engine Manual.

SERVICE PARTS

Order the following parts through your
Dealer:
Part No.
00036800 Stens Mix Hi-Temp Grease
21533400 Spark Plug
07200007 Impeller Belt
07228600 Traction Belt
51001500 Shear Bolt Kit
03248300 Friction Disc
To obtain a complete parts manual, find your
model and serial number. Then go to
www.ariens.com or call 1-920-756-4664.

ACCESSORIES

See your authorized Ariens dealer to add the
additional accessories available to your
Sno-Thro.
Part No.
72403600 120 Volt Starter Kit
72402200 240 Volt Starter Kit*
72406500 Front Weight Kit
* Available in CE countries.
GB - 26
Description
(3, 3 oz. cartridges)
Description