Serene CA-PX User Manual page 10

it wi ll exit the Learn mode.
4. Press and hold the test button on the accessory
CA-AX (audio sensor) for more than 10 seconds
until CA-PX flashes, vibrates, and beeps (if
spea ker is On) twice.This confirms the learning .
5. Repeat the steps 3 and 4 with the CA-DXH
accessory.
6. Press the Reset butto n on the CA-PX to exi t the
learn ing mode at any time.
7. Test th e system - Press the Test button on each
accessory one at a time . Verify that th e
corresponding icon button on the CA-PX is
activated . The CA-PX wi ll flash , vibrate and beep
(if speaker is On) for about 45 seconds. Press
Reset to stop at any ti me.
8. Repeat the test with the CA-DXH. Press Reset to
stop at any time.
9. Repeat the steps above to learn (or reg ister) and
test more accessories as desired .
2.
Learning CA-PX into a CA-360 System
Example Application
This is a typical application for adding a CA-PX to a
CA-360 system, in order to improve mobility freedom
and coverage area .
Each CA-PX must be learned (or registered) to the
CA-360 system before before it can be recognized
(Up to 10 CA-PX may be added to on e CA-360 master
unit).
Note: All previously learned accessories in the
CA-PX will be lost during this process, and all lost
accessories must be learned again through the
CA-360 master unit.
10