Table of Contents
Advertisement
Installation notes by EasyGate for Terrier Swing gate arm using CB17 control
board.
Unpack product.
Check that all items are present and are in good condition. Check also inside the control
box for remotes and other product that may have been packed inside. Before each order
is dispatched a check sheet is completed. Please notify EasyGate immediately if you
suspect missing parts. No claims accepted unless notified within 7 days of delivery.
Standard Double kit includes: Instruction manual, 2 x actuator arms, 4 x arm-
mounting brackets, 2 x gate bracket cylinder pins with grub screws, 2 x post bracket
bolts and nuts, 2 x arm unlocking keys, 1 x control box, 2 x batteries fitted under control
board, 1 x control board, 1 x stand-alone transformer, wireless keypad, 1 x push button
(wired) and 3 x remotes.
Standard Single kit includes: Instruction manual, 1 x actuator arms, 2 x arm-
mounting brackets, 1 x gate bracket cylinder pins with grub screw, 1 x post bracket bolts
and nuts, 1 x arm unlocking keys, 1 x control box, 2 x batteries fitted under control
board, 1 x control board, 1 x stand-alone transformer, wireless keypad, 1 x push button
(wired) and 3 x remotes.
Post and gate arm brackets: The brackets provided can be configured a number of
different ways to achieve the correct operating conditions. For best results, remember
the greater the angle that the arm is attached to the gate the greater the force the arm
will exert on the rubber stop in the middle of your driveway at the closed position! This
will add to the security of the gates when closed. An arm fitted parallel to the gates will
damage the system and rip the brackets from the gate as well as producing a sloppy
installation system. In some cases such as stone pillars, it maybe be easier to install a
separate post to mount the bracket onto. You can also shorten the tongue with a
hacksaw and re-drill the hole if your post is wider than approximately 125mm.
2
Hide quick links:
Advertisement
Table of Contents
