Leading Edge - Formax FD 1400 Quick Setup Manual

http://www.monomachines.com/
For More Info
Click Here --->
Make copies of this page on copy paper for fine tuning folds
Instruction For Lining Up Folds Instruction For Lining Up Folds
1. Place a stack of these sheets into the feeder and fold
one (1) or two (2) sheets.
2. Take a folded sheet from the catch tray and lay it on
top of a pressure seal form lining the leading edge of
this sheet up with leading edge of the pressure seal
form.
3. If the folds on this test sheet do not line up with the
perforated folds on the form, the fold plates need to
be adjusted up or down to make the folds line up.
Refer to Fig. 1 for a "Z" fold and Fig. 2 for a "C" fold.
- If fold "A" on the test form is right of the perforation on
the pressure seal form move the top fold
stop up. If fold "A" is below move the top fold plate
stop fold stop down.
- If fold "B" on the test form is right of the perforation
on the pressure seal form move the bottom fold plate
stop down. If fold "B" is to the left move the bottom
fold plate stop up.
http://www.monomachines.com/

Leading Edge

 
Fig. 1 "Z" fold Form
plate
Fig. 2 "C" Fold Form
Fold "A" Fold "B"
Fold "A" Fold "B"
Leading Edge Leading Edge
Leading Edge Leading Edge