Advertisement
Wireless Remote Controller Kit
How to Use / How to Install
1
Making Sure of Components
Make sure that the following components, along with this manual, are packed in the box.
Component
Wireless remote controller reciever
Wireless remote controller
Remote control holder
"AAA" LR03 alkaline batteries
4.1×16 wood screws
Cord retaining clips
Connection cord fixing seal (12×30 size)
How to Install
2
Removing the intake grille and the right side panel
• Slide the catch holding the intake grille backwards to open the grille. Remove the screw holding the side panel,
and then slide the side panel forward to remove it.
Removing the existing brand label case
• Remove the brand label case (name plate with MITSUBISHI ELECTRIC) from the bottom right of the unit. If it is difficult
to remove the case, use a flat-blade screwdriver, etc., taking care not to damage the panel.
Installing to the indoor unit
• Pass the receiver board connector through the right side of the square hole to which the brand label case
was attached and then pull the connector and cord thruogh the slit in the right side of the bottom panel.
• Fit the receiver into the square hole where the brand label case was attached.
Slit
E-130
for Ceiling Suspended models
Be sure to turn the power off before installing.
Slide
Slide
Catach retaining the intake grille
Panel
Case
Panel
Retaining clip
PAR-SL94B-E
Q'ty
1
1
1
2
2
2
1
Remove the screw holding the side panel
Side panel
Slide forward
Advertisement
