Status Led - Vivotek IP7138 User Manual

General I/O Terminal Block
This Network Camera provides a general I/O terminal block which is used to connect external
input / output devices. The pin definitions are described below.

Status LED

The color of LED indicates the status of the Network Camera�
Status LED color
Steady green and blink red (once)
Steady green
Steady orange (green + red) till IP address is confirmed
Blink green / orange every second and steady red
Blink orange every second and fast blink red
Hardware Reset
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after reset, restore the factory settings and install again�
Reset: Press and release the indented reset button with a paper clip or thin object� Wait for the
Network Camera to reboot�
Restore: Press and hold the reset button until the status LED rapidly blinks� It takes about 30
seconds� Note that all settings will be restored to the factory default�
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
Pin Name
1 Digital output
2 Digital input
3 DC power
4 Ground
Loading system after power on
During booting procedure
Detecting and setting network
After network is setup (system up)
During the upgrade firmware process
Description
User's Manual - 5