Samsung HW-H450 User Manual page 11

CONNECTIONS
CQNN}!CT ONS
_NSTALUNG 'THE WALL MOUNT
You can use the watt mount bracket to raount this unit on a watt,
Installation Precautions
• tnstatt on a ve_icat watt onty,
• For the installation, avoid a tocation with high temperature or
humidity, or a watt that cannot sustain the weight of the set,
• Check the strength of the watL tf the watt is not strong
enough to support the unit, reinforce the watt or instatt the
unit on a different watt that can support the unit's weight,
• Purchase and use the fixing screws or anchors appropriate for
the kind of wan you have (plaster board, iron board, wood,
etc,), tf possible, fix the suppo¢ screws into watt studs,
• Purchase wan mounting screws according to the type and
thickness of the watt you wit1mount the Soundbar on,
Diameter : M5
Length: t 3/8 in (35 mm) or tonger recommended,
• Connect cables from the unit to extemat devices before you
install it on the watt,
• Make sure the unit is turned off and unplugged before you
instatt it, Othe_vise, it may cause an electric shock,
!. Placethe installation guide against the watt su,fface,
• The installation guide must be tevel,
• tnstatt at least 2 inches (5 cm) below the %/, if the TV is
mounted on the watt,
2. Mark the tocation where the screws wit1go through on the
watt using a pen, and then remove the installation guide,
3. Fastenthe watt mounts and screws to the marked locations,
• The 1eftand right mounts are different shapes,
4. Secure the two hotder screws to the screw holes on the back
of the Soundbar's main body, one on the 1eftand one on the
right,
5. Insert the USBcable into the back of the Soundbar before
installing it on the watt,
6. Set the hotder screws on the back of the Soundbar into the grooves of the watt mount_
For safe installation, make sure to push the hotder screws att the way to the bottom of the grooves,
11