User Interface - Curtis DVB102UK User Manual

User Interface

The 'Exit ' key will remove all digital menus.
The exception to this is for persistent banners i.e. encrypted service
etc and for service locked/censorship PIN entry OSDs.
All menus will automatically be removed after 30 seconds unless
otherwise stated.
The menus use a 256-colour palette.
The menus will currently support just English language.
1)Welcome Screen
When the STB is powered up for the first time or is brought out of
standby with no services, then a welcome screen will be displayed.
This will tell the user to press the OK key to start a full frequency
service scan.
2) Volume Control
A bar is to be displayed when volume is changed by pressing Vol+ or
Vol-. The bar will disappear after a predefined time following the last
Vol+ or Vol- key press.Automatically removed after 2 seconds.
3) Mute Symbol
Pressing the Mute key mutes the sound and a symbol is displayed,
Automatically removed after 2 seconds.
4) Screen Freeze
Pressing the Pause key to Freeze the Screen and a pause symbol is
displayed. Press the Pause key again to exit Freezing.
5) Direct Digit Entry
When the user initiates a channel change using the number keys,
The user can press the OK key to force the channel change before
all 3 digits have been entered. If all 3 digits are entered then the
channel change will occur.
5 seconds after the last key press, the channel change will be
initiated if all digits have not been entered.
6) TV/Radio Switch
Press TV/Radio button on the remote to toggle between TV channels
and Radio stations, then you can change among the TV channels or
Radio stations by pressing CH+/- buttons. This mode can be
removed later if you select a channel by Direct Digit Entry or Service
Organiser.
Press to set-up services on your receiver
OK
5
3