Setting up
Install the LED DERBY III so that the front panel is facing the area to be lighted.
Experiment with positioning to get the best coverage from the multi-beam array.
Connect mains using an appropriate IEC lead to the mains inlet
Operation
The LED DERBY III operates as a stand-alone unit in either auto or sound-activated modes.
Settings are accessible via the 10 dip switches situated on the rear panel.
Sound activated mode is governed by a rotary sensitivity control on the rear panel.
Turning this control clockwise increases the sensitivity of the rear panel mounted microphone
Rear Panel
DIP Switch settings
DIP switche(s) on
10
10 + 5
10 + 4
10 + 2 + 1
9 + 10
Effect
Auto colour jump with slow rotation
Auto colour fade + jump with slow rotation
Fast auto colour jump with slow rotation
Auto colour jump with fast rotation
Sound-activated with slow rotation when no sound detected
1
Number 1 to 10 dip switches
2
Power on/off switch
3
Sound-activation microphone
4
Rotary Mic. Sensitivity control
5
Mains inlet (IEC) & Fuse holder
151.577UK User Manual