Ariens Sno-Thro 920001- ST624E Owner's/Operator's Manual page 11

Ariens snow blower owner/operator manual
Hide thumbs Also See for Sno-Thro 920001- ST624E:
Table of Contents

Advertisement

Throttle
The throttle controls the engine speed.
To increase or decrease the engine
1
speed, adjust to:
2
1. Fast (normal or warm starts)
2. Part-Throttle
3
3. Slow (cold weather starts)
4
4. Stop (engine is off)
Electric Starter
The electric starter will start a properly choked and
cranked engine when the starter button is pushed.
Refer to Starting and Shut Off on page 13.
Recoil Starter Handle
When pulled, handle will turn engine over.
IMPORTANT: DO NOT let handle snap back against
starter.
See Starting and Shut Off on page 13.
Snow Clean-Out Tool (Figure 8)
WARNING: Hand contact with the rotating
impeller is the most common cause of injury
associated with snow throwers. Never use
your hand to clean out the discharge chute.
To clear the discharge chute:
1. Shut off the engine.
2. Wait 10 seconds and make sure impeller blades
have stopped rotating.
3. Remove the snow clean-out tool (1) from the
auger housing and use it to remove the clog from
the discharge chute.
4. Replace the snow clean-out tool on the auger
housing.
Discharge Chute Deflector
ALWAYS position discharge chute deflector at a safe
angle before starting engine.
DO NOT throw snow any higher than necessary.
1
1. Snow Clean-Out Tool
OS8040
Figure 8
Push deflector handle forward or down to throw snow
lower. Pull deflector handle up or to the rear to throw
snow higher.
IMPORTANT: If Chute Deflector does not stay in set
position, adjust as directed in SERVICE AND
ADJUSTMENTS on page 16, or repair before
operation.
Discharge Chute
Discharge chute rotates 186°.
ALWAYS position discharge chute in safe direction and
angle, away from operator and bystanders, before
starting engine.
Discharge Chute Crank
IMPORTANT: If chute does not stay in set position,
adjust as directed in SERVICE AND ADJUSTMENTS
on page 16, or repair before operation.
Rotate the chute with the discharge chute crank
handle.
IMPORTANT: DO NOT force frozen chute controls. If
frozen, take to warm place until controls are free.
Axle Lock Pin (Figure 9)
Use the axle lock pin to lock or unlock the right or left
wheel. Lock both wheels to increase traction; unlock
one wheel to allow for easier turning of the unit.
NOTE: Unit will not drive with both wheels unlocked.
GB - 11
Wheel Unlocked
Axle Lock Pin
Wheel Locked
Figure 9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sno-thro 920001-st624eSno-thro st624e920001

Table of Contents