Table of Contents
Advertisement
Highlighting the box under the "Activation Time" heading allows you to set the duration before the recorder
will report a Video Blind. The recorder will not consider any blinded camera to be a Video Blind if the detected
blindness is less than the Activation Time set on this screen.
Highlight the box under the "Actions" and press the
button. The recorder can be set to react to video blind
differently for each camera. Each camera can be associated with another camera, trigger an Alarm-Out
connector, sound the recorder's internal buzzer, notify a number of different devices, move PTZ cameras to
preset positions, and/or display a camera on a SPOT monitor.
Highlight "Use Ignoring Time" and press the
button to toggle between On and Off. When set to On, the
recorder will ignore video blind events occurred during the preset period. Highlighting "Time Setup" and press
the
button allows you to set up event ignoring time.
Text-In
Figure 40: Event – Text-In setup screen
The recorder can be set to react to text input from devices. This screen allows you to configure the recorder for
each text-in device.
Highlight the box under the "Setup" heading, and press the
button. Selecting the "Setup" heading changes
all the parameters excluding Port settings of all the text input channels.
Note: The system performance might be affected when a large quantity of text inputs are detected
from several channels at the same time.
Figure 41: Text-In – Port setup screen
Highlight the box beside "Port", and press the
button. Select from "None", "RS232", "RS485", "USB-Serial"
(1 – 8) and "LAN" (1 – 16).
39
Advertisement
Table of Contents
