RE252T 2GIG-Compatible PINpad™
Features
Secure, 4-digit Code to disarm
•
1-button arming
•
Red/Green LED arming feedback
•
Small, yet comfortable keypad
•
Mounts on wall via VHB® tape, or screws
•
Secure for carrying in purse or mounting on car visor
•
4-6 year battery life on CR2032 battery.
•
Key Instructions
Program as a RF Key Fob, NOT a RF Keypad
•
PIN Code programming
•
Default access code is "1234".
To change access code: Do these steps within 4 seconds
1. Enter current 4-digit access code.
2. Press and hold the "1" and "3" keys simultaneously.
(after 3 seconds, Red LED will be lit)
3. Enter new 4-digit access code.
(the Green LED will be lit)
Note new access code . BAD GUY CANNOT RESET CODE.
So it must be recorded and remembered!
2GIG Go! Panel:
Question
Q3:
Select fob # (1-8)
Select fob 1 used (0-1)
Select fob 1 equipment code
Enter fob 1 other equipment code (0-9999)
Enter fob 1 serial number
Select fob 1 equipment age
Select fob 1 emergency key (0-4)
Construct RF Keypad Voice Descriptor
Operation
PINpad
Panel Action
Button
Stay
ARM STAY
Away
ARM AWAY
PIN Code
DISARM
Stay + Away
PANIC ALARM
RE252T_2GIG-Compat_PIN-Pad
Page 1 of 3
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
Answer
[1] keyfob one
[1] used
[0000] other
252 (RE252)
Go! Panel: Shift+Learn
PINpad Keypad: STAY
[0] new
[2] audible alarm
keypad one
LED
flashes double red
flashes double red twice
flashes double green
flashes red 8 times
16-May-14
Pictures
TO CHANGE PIN CODE:
Current 4-digit access code, and then...
1 + 3
Enter New Code
Red/Green
Status LED
Shows command sent
Stay
Loop 4
Battery Replacement
Insert Screwdriver
here
to open
RE252T_2GIG-Compat_PIN-Pad
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
Red LED,and then...
Entering
Code
Sends Disarm
Loop 2
Away
Loop 3
Stay + Away
Sends Panic
Loop 2+3
CR2032 Battery
+ Terminal up
Page 2 of 3
16-May-14