Page 1
97Te, 95Te Treadmills A ss em bl y I ns tru c ti o ns...
Page 2
The following Parts Identification Listing and the step by step assembly procedures have been assembled to make the set-up of this treadmill as quick and easy as possible. Please take special note of the following important points prior to choosing a...
If any parts are missing, contact Life Fitness Customer Support Services at the number listed on the back page of this assembly instruction booklet.
Page 4
OOLS EQUIRED FOR Phillips screwdriver, Torx wrench, 3/4” combination wrench, flat blade screwdriver (or 5/16” nut driver) LEFT UPRIGHT HANDLEBAR (LEFT AND RIGHT) LEFT INSIDE HANDLEBAR SHROUD LEFT OUTSIDE HANDLEBAR SHROUD DISPLAY CONSOLE LEFT ACCESSORY TRAY HANDLEBAR CAP HANDLEBAR SHROUD SCREW 0017-00101-1770 DISPLAY CONSOLE / HANDLEBAR SUPPORT SCREW 0017-00101-1773...
Page 5
THE FRAME (C). With the bend of one HANDLEBAR (#3) directed to the outside of the treadmill, insert the HANDLEBAR into the RIGHT UPRIGHT HANDLEBAR BRACKET (L) as shown. Be sure the HANDLEBAR MOUNTING HOLES are aligned. Repeat for the left side HANDLEBAR.
Page 6
Align the ERGO FRONT CROSSBAR MOUNTING HOLES with those in the RIGHT UPRIGHT HANDLEBAR BRACKET and secure using two BOLTS (#19), from the inside of the treadmill, and NUTS (#22). Tighten the BOLTS securely. Insert one SCREW (#16) from under the RIGHT UPRIGHT HANDLEBAR BRACKET.
Page 7
SCREWS. Install the WAX BAG. Follow the instructions included in the WAX BAG KIT. Refer to the Operation Manual for power requirements, proper line cord routing, and other critical product information before connecting the treadmill to a power source.