Planar LA1910R User Manual page 10

Connecting the display
To set up this display, please refer to the following fi gure and procedures.
1. Be sure all equipment is off.
2. Connect the DC power cord to the power connector. Plug one end of the
AC power cord into the power adapter, and the other end into an electrical
outlet(1).
3. For the PC with Analog graphics output: connect the VGA signal cable from
display VGA input connector to the 15-pin VGA connector of your host
computer and tighten the screws(2).
4. For DVI-D output: connect DVI cable from display to the PC(2a).
5. For the LA1910RTC touch screen model confi gure the touch screen. Refer
to the "Touch Screen Driver Installation" section on page 24.
6. Turn on your computer, display and video source.
Notice: To ensure the LCD display works well with your computer, confi gure
the display mode of your graphic card to less than or equal to
1280 x 1024 resolution and make sure timing of the display mode is
compatible with the LCD panel. "Video Modes" of this LCD panel are
listed in the appendices for your reference.
10
LA1910R and LA1910RTC User's Guide (
(Figure 1.1)
020-0321-01A)