Service And Adjustments; Figure - Ariens 924124-ST926DLE, 924125-ST11528LE, 924126-ST11526DLE, 924127-ST11528DLE, 924128-ST1332LE, 924335-ST926DLE, 924336-ST11526DLE, 92 Owner's/Operator's Manual

2
1 1
CLEAN BATTERY (924516, 517)
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
IMPORTANT: Battery is maintenance free. Do
not tamper with or attempt to open battery.
See Service and Adjustments for charging
procedures.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
DEFLECTOR REMOTE
Deflector must stay in selected position while
throwing snow.
If deflector does not stay in set position:
1. Tighten nut beneath the control panel to
increase friction on pressure flange

(Figure 16).

1 1
1. Auger and Shaft
2. Discharge Chute
3. Sprocket/Pinion
Assembly
4. Axle Shaft

SERVICE AND ADJUSTMENTS

8
6
7
3
5. Shift Lever Arm
6. Pinion Chain
7. Hex Shaft
8. Shift Link
Figure 15
Terminals
Keep battery and its terminals clean.
IMPORTANT: Remove battery from unit
before cleaning.
Remove corrosion from battery terminals and
cable connections with a wire brush, then
wash with a weak baking soda solution.
After cleaning, apply a thin coat of grease or
petroleum jelly to terminals and cable ends to
retard corrosion.
If deflector does not follow full range of travel:
1. Push deflector remote all the way
forward.
2. Loosen adjusting nuts on cable support
bracket.
3. To adjust the deflector lower:
Slide cable down. Tighten bottom nut.
4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
GB - 21
5
4
Grease
Oil
OS0642
OS0741