Use - Miele TX2070 Operating Instructions Manual

en
 Take out the accessory you require.
 Press down firmly on the lid to close
it.
Dusting brush integrated in the
EcoComfort handle (dia. 15)
The dusting brush is suitable for vac‐
uuming scratch-resistant surfaces, e.g.
keyboards or vacuuming up crumbs.
 Release the dusting brush and push
it over the guide until it clicks into
place.
 When you have finished dusting re‐
lease the dusting brush and push it
back into its original position until it
clicks into place.
EcoTeQ / AirTeQ floorhead (dia. 16)
For general use and also for vacuuming
the stairs.

For safety reasons when vac‐
uuming stairs it is best to start at the
bottom of the stairs and move up‐
wards.

Use

Unwind the mains cable (dia. 17)
 Pull the mains cable out to the re‐
quired length (max. cable length ap‐
prox. 7.5 m).
 Insert the plug into the socket cor‐
rectly and switch on.

If vacuuming for longer than 30
minutes, the mains cable must be
pulled out to its fullest extent. Other‐
wise there is a danger of overheating
and damage.
34
To rewind the cable (dia. 18)
 Switch off at the wall socket and
withdraw the plug.
 Press the rewind foot switch briefly.
The cable will rewind automatically.
Switching on and off (dia. 19)
 Press the On/Off foot control .
To regulate the suction power
(dia. 20)
The suction power can be regulated to
suit the type of flooring being cleaned.
Reducing the suction power reduces
the amount of effort required to ma‐
noeuvre the floorhead.
The vacuum cleaner has symbols on
the controls which indicate the type of
use the settings are suitable for.
 Curtains, fabric
 Upholstery, cushions
 Deep pile carpets, rugs and run‐
ners
 Energy-saving vacuuming. This
setting is also very quiet
 Loop pile carpet and rugs
 Hard flooring and heavily soild
carpets and rugs
When using the floorhead, if the suc‐
tion seems too high, reduce the suc‐
tion until the floorhead is easier to ma‐
noeuvre.
The first time the vacuum cleaner is
switched on, the highest setting will be
selected automatically.