Advertisement
E
F
8
G
H
Hedge Trimmer
4. StARtING AND StoPPING (See fig e, f)
BefoRe StARtING yoUR HeDGe tRIMMeR
Remove Blade Sheath (7).
to StARt yoUR HeDGe tRIMMeR
There are two switch levers fitted in your Hedge
trimmer (2&3).
Both switch levers need to be depressed for the product
to StARt. Depress and hold the Front Switch Lever (3)
and depress the Rear Switch Lever (2). (See Fig. E)
to StoP yoUR HeDGe tRIMMeR
Move Hedge trimmer away from cutting area before
I
stopping.
To StoP, release one of the switch levers. (See Fig. F)
WARNING: If any parts are missing, damaged or
broken, do not operate your Hedge trimmer until
all damaged parts have been replaced or repaired.
Failure to do so could result in serious personal injury.
DO NOT USE WITHOUT HANDLE AND GUARD
5. HoW to USe yoUR HeDGe tRIMMeR
Inspect the area to be cut before each use, remove
objects which can be thrown or become entangled in
the cutting blades.
Always hold the Hedge trimmer with both hands and
with the blade away from you before turning it on.
Always keep the power cord behind the Hedge
trimmer when in use. Do not place it over the
hedge that you are trimming where it may be cut
by the blade.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the blade.
Allow the cutting blades to reach full speed before
entering the material to be cut.
Always work going away from people and solid objects
such as walls, large stones, trees, vehicles etc.
If the blade stalls, immediately stop the Hedge trimmer.
Disconnect the Hedge trimmer from the mains and clear
the jammed debris from the cutting blades.
Wear gloves when trimming thorny or prickly growth.
Move the Hedge trimmer to feed the branches directly
into the blade cutting edges.
Do not try to cut stems that are too large to feed into the
cutting blade.
toP cUttING (See G)
Use a wide sweeping motion. A slight downward tilt of
the cutting blades in the direction of motion gives the
best cutting results.
SIDe cUttING (See H)
When trimming the sides of the hedge, begin at the
bottom and cut upwards, tapering the hedge inward
WG212E
Advertisement
