Table of Contents
Advertisement
(a) Listening to the radio
1. Push the "AM
S
FM" button to turn the
radio on and select either an AM or FM
broadcast.
"AM" or "FM" will appear on the display.
The radio can also be turned on by push-
ing the "PWR VOL" knob if the radio was
on when the system was turned off.
2. Turn the "PWR VOL" knob to adjust the
volume.
3. Tune in the desired station. (See "(b)
Selecting a station" and "(c) Presetting a
station".)
The radio will change automatically to ste-
reo reception when an FM stereo broad-
cast is being received. At the same time,
"ST" will appear on the display. When the
receiving signal gets weak, the channel
separation will automatically be reduced
for the lowest noise. If the signal becomes
extremely weak, the radio will switch over
to monaural reception.
4. Adjust the tone and sound balance.
(See "(d) Adjusting the tone" and "(e) Ad-
justing the sound balance".)
5. To turn the radio off, push the "PWR
VOL" knob.
(b) Selecting a station
Tune in the desired station using one of
the following methods. The frequency will
appear on the display.
Preset tuning: Use for tuning-in to a de-
sired preset station. (See "(c) Presetting
a station".)
Push the station selector button which
has been preset to the desired station.
The radio will tune in to the station and the
button number will appear on the display.
Seek tuning: Use for automatic station
search and stop.
Push the "TUNE (REW FF)" button on ei-
ther side and hold it until a beep is heard.
The radio will begin seeking up or down for
a station of the nearest frequency and will
stop on reception. Each time you push the
button, stations will be sought out one af-
ter another.
Scan tuning: Use for station-to-station
scanning.
Scanning for all frequencies—Push the
"SCAN" button and hold it until a beep is
heard. With "SCAN" on the display, the ra-
dio will automatically seek out a station of
a higher frequency, hold it for 5 seconds
and scan to the next. To continue listening
to the broadcast of your choice, simply
push the "SCAN" button once again.
If the radio scans over all frequencies
without stop because the signals are too
weak or just because you leave it going,
the radio will begin scanning again with
sensitivity boosted for searching out weak
stations.
Scanning for preset stations—Push the
"SCAN" button within 2 seconds. With
"SCAN" on the display, the radio will auto-
matically seek out a preset station, hold it
for 5 seconds and scan to the next. To
continue listening to the station of your
choice, simply push the "SCAN" button
once again.
Manual tuning
Push the "TUNE (REW FF)" button on ei-
ther side for less than 0.5 second. Each
time you push the button, the radio will
step up or down to another frequency
where stations could exist.
(c) Presetting a station
1. Tune in the desired station. (See "(b)
Selecting a station".)
2. Push one of the station selector but-
tons and hold it until a beep is heard. This
sets the station to the button and the but-
ton number will appear on the display.
Each button can store one AM station and
one FM station. To change the preset sta-
tion to a different one, follow the same pro-
cedure.
91
Advertisement
Table of Contents
