To Remove Drive Belt; Service And Adjustments - Husqvarna HU800AWDH Operator's Manual

Table of Contents

Advertisement

Available languages

Available languages

SERVICE AND ADJUSTMENTS

CAUTION: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
1. Release control bar and stop engine.
2. Make sure the blade and all moving parts have completely stopped.
3. Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in the Operation
section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the rear wheels of
your mower, is provided to minimize the possibility that
objects will be thrown out of the rear of the mower into
the operator's mowing position. Replace the rear deflec-
tor if damaged.
REAR
BAFFLE
DEBRIS
SHIELD
BLADE
HARDENED WASHER
LOCKWASHER
BLADE BOLT
TO REMOVE DRIVE BELT (See Figs. 20 & 21)
NOTE: Before tipping lawn mower to remove drive belt,
empty fuel tank by running engine until fuel tank is empty.
1. Turn lawn mower on its side with air filter and car bu re-
tor up.
2. Remove blade bolt, lockwasher, hardened washer and
blade.
3. Remove debris shield.
4. Remove side bumper.
5. Remove rear baffle.
6. Disconnect return spring from rear baffle / rear gearcase
belt keeper.
7. Disconnect cable from rear gearcase.
FIG. 20
15
SIDE
BUMPER
DRIVE
COVER
FRONT
BAFFLE

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents