LG NP8350 Simple Manual page 24

24
2. If you change the location of the speaker that is in use,
2-1. If the changed location is too far from the home router,
2-2. Connect the speaker with a LAN cable, and for
There are times that speaker disappears from the
application
1. If the speaker blinking lamp is not blinking, and stays
as white: Even after the speaker power off and on, if the
problem continues, in this case you have to reset the speaker
(To reset, press and hold the
until you hear one beep.) then you need to register again.
Carry out speaker installation or additional procedures.
2. If the speaker blinking lamp blinks white - network signal is
unstable. Wait for a while, or move the speaker to another
location closer to another speaker or router.
3. Press menu key or menu at the top right side of Home screen
to end Music Flow Player app and run again.
Music sound breaks and unstable MUSICflow
system
1. If speaker with breaking sound is connected through wireless
connection mode,
y If the distance between the speaker and home router is
P8350B-M0.BUSALLK_SIM_ENG_MFL68922630.indd 24
Troubleshooting
it may not be connected. Place and use it at a location
that is close enough to router.
additionally installed speakers, if they are not close
enough to the speaker connected with a LAN cable,
additionally install Bridge or another speaker in the
middle location between the speaker connected
with LAN cable and the speaker with sound being
disconnected.
not close enough, the corresponding condition may occur.
Move the speaker closer to the home router and try again.
(ADD) button for 8 seconds
2015-04-02 2:31:55