Adjusting The Direction Of Air Circulation - Fujitsu ABYG18LVTB Operating Manua

ADJUSTING THE DIRECTION OF AIR CIRCULATION

Instructions relating to heating (*) are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
● Adjust the up, down, left and right air directions with the air direction buttons on the Remote Controller.
● Use the air direction buttons after the Indoor Unit has started operating and the airflow-direction louvers have stopped
moving.
Vertical Air Direction Adjustment
Press the SET button (Vertical).
Each time the button is pressed, the air direction range will change as follows:
1
Types of Airfl ow Direction Setting:
: During cooling/dry modes
1, 2, 3, 4
: During heating mode*
5, 6, 7
The remote controller's display does
not change.
● Use the air direction adjustments within the ranges shown above.
● The vertical airfl ow direction is set automatically as shown, in accordance with the
type of operation selected.
During cooling/dry mode
During heating mode*
● During AUTO mode operation, for the fi rst minute after beginning operation, airfl ow
will be horizontal 1 ; the air direction cannot be adjusted during this period.
The airfl ow direction setting will temporarily become 1 when the temperature of the
airfl ow is low at the start of the Heating mode.
Horizontal Air Direction Adjustment
Press the SET button (Horizontal).
Each time the button is pressed, the air direction range will change as follows:
1
The remote controller's display does
not change.
● Use the air direction adjustments within the ranges shown above.
2 3 4 5
: Horizontal fl ow 1
: Downward fl ow 7
2 3 4 5
Right/left air direction louvers
Never place fi ngers or foreign objects inside
the outlet ports, since the internal fan ope-
rates at high speed and could cause personal
6 7
injury.
DANGER
● Attempting to move up/down air direc-
tion flaps or right/left air direction lou-
vers manually could result in improper
operation; in this case, stop operation
and restart. The louvers should begin to
operate properly again.
● During use of the cooling and dry
modes, do not set the up/down air di-
rection flaps in the heating range (5
to 7 ) for long periods of time, since
water vapor may condense near the
outlet louvers and drops of water may
drip from the air conditioner. During the
cooling and dry modes, if the airflow
direction louvers are left in the heating
range for more than 30 minutes, they
will automatically return to position 4.
●
When used in a room with infants, chil-
dren, elderly or sick persons, the air
direction and room temperature should
be considered carefully when making
settings.
En-11