Advertisement
The use of measures or procedures other than those specified here may cause hazardous radiation exposure.
• Never look in the direction of the laser beam.
• Do not aim the laser at people or animals.
• Do not use the laser on highly reflective materials. Reflected light is equally dangerous.
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER DEVICE
SPECIFICATIONS
Motor:
2 0 0 0 W - 2 3 0 V AC 50Hz
Speed:
5 5 ° o min"
1
Blade size:
255x30x3.2 mm (40 teeth)
Crosscut at 90°:
82 x 340 mm
Mitre cut at 45° Land R:
82 x240 mm
Bevel cut at 45° Land R:
50 x340 mm
Compound cut 45° R and 45
0
R:
25 x240 mm
Compound cut 45
0
Land 45° L:
25 x240 m m
Mitre stops R and b
o ° - 1 5 ° - 22.5° - 30° - 45° R & L
Bevel stop:
0° and 45°
Laser:
Class 2
Net weight:
20 kg
Gross weight:
25 kg
UNPACKING AND CLEANING
Your new mitre saw with dual bevel is shipped complete in a carton. Unpack it and all spare parts carefully as well and check
that it has not been damaged in transit. All unpainted parts are protected by an anti-rust film. Remove the protective coating
of all parts that are not painted before using the tool for the first time.
Note: If parts are damaged or missing, do not connect the mitre saw and do not turn the switch t o "on" until the damaged or
missing parts have been obtained and properly installed.
Do not discard the carton in which the machine came before it is completely mounted.
1. Place the mitre saw on a level surface.
2. The saw comes with its head locked in the lowest position.To release it, push the saw head down, pull and turn the release
pin (A) Fig.17.
IMPORTANT: Do not lift the tool with the starting handle, always lock the head in the transport position and lift the saw by
the base or the carrying handle if there is one.
CAUTION:
Do not use gasoline or other petroleum-based solvent for cleaning the machine after unpacking; these products are ex-
tremely flammable. A risk of explosion or fire exists if these products are used. In general, all solvents used for cleaning
machines are toxic when inhaled or ingested. Always work in a well ventilated area away from potential sources of solvents.
Wear a mask.
LH
P E U G E O T
IDENTIFICATION OF THE MACHINE
A.srart/stop handle
H. i )n/off switch for the laser
1 On/off trigger switch
n. s.iw Blade
I. lower blade guard
C.Double beam laser
0. Cable extension wings
II.'.aw table
1. I.ible insert
l.l.ible rotation handle
K. Rotary table scale
L. Cut stop guide
M.Cuide locking handle
N.Clamp
O.Saw head bevel locking handle
P.Saw head slide mechanism
O.Dust bag
R.Mitre angle scale
S.Depth stop
T. Upper blade guard
INSTALLATION
/[^CAUTION: Make sure the saw is turned off and unplugged from any power source before proceeding with the a
lly or performing any other adjustment.
1. ASSEMBLING THE TABLE ROTATION HANDLE
You must mount the table rotation handle before you can use your dual bevel mitre saw(A) Fig.2.
li> do this, screw in the handle (A). This handle is used to lock the table at the desired angle for mitre cuts.
Advertisement
