Fcc Rf Interference Statement; Connecting With External Equipment - Orion Premium Line 097RTH User Manual

FCC RF INTERFERENCE STATEMENT

NOTE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio, TV technician for help.
- Only shielded interface cable should be used.
Finally, any changes or modifications to the equipment by the user not expressly approved by the grantee or
manufacturer could void the users authority to operate such equipment.
DOC COMPLIANCE NOTICE
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital
apparatus set out in the radio interference regulation of Canadian Department of communications.
9.7-INCH VALUE LED CCTV MONITOR ··············· 05 06 ··············· 9.7-INCH VALUE LED CCTV MONITOR

CONNECTING WITH EXTERNAL EQUIPMENT

A. FRONT
Input Menu
① ② ③
1. INPUT
Selects AV or HDMI inputs.
Selects an option in the OSD.
2. MENU
Activates or exits the OSD.
Moves previous menu or status in the OSD.
3, 4. ▲, / ▼,
Moves another option in the OSD.
5. (POWER ON/OFF)
Turns the power on or off. There will be a few seconds delay before the display appears.
6. POWER LED
Turned on with VGA or AV signals : Green color.
Turned on with no signal : 1) AV mode: Green color
2) VGA(PC) mode: Blinking green color.
Turned off : LED off.
④ ③ ④ ⑤ ⑥