INTERFACE
TIME SETTING
*Before setting the time, check that the watch time measurement is stopped.
1. Pull out the crown when the second hand is at the 12 o'clock position. The second hand will
stop on the spot.
2. Set the hands to the desired time of day by turning the crown.
*make sure that AM/PM is set correctly.
*Do not press any button, otherwise the watch hands will move again.
3. Push the crown back in to the normal position in accordance with the new minute starting.
ADJUSTING THE STOPWATCH HAND POSITIONS
Before setting the time, check that the stopwatch second and minute hands are in the "0" (12
o'clock) position.
*If the stopwatch is in use, press the buttons in the following order to reset it, then you can check to
see that the hands have returned to the "0" position.
(For further details, see "HOW TO USE THE STOPWATCH")
*If the stopwatch is counting: (A)
*If the stopwatch is stopped: (B)
*If the split time is displayed: (B)
*If either of the stopwatch hands are not in the "0" position, reset them by following the procedure
below.
1. Pull out the crown.
2. Press button (A) or (B) to reset the stopwatch second and minute hands to the "0" position.
*By pressing (A), the hands move clockwise.
*By pressing (B), the hands move counter clockwise.
3. Push the crown back into the normal position.
Kogan Men's Azure Watch
KAWTCSSBLU
Quick Start Guide
➨
(B)
➨
➨
(A)
(B)
Need help?
Do you have a question about the KAWTCSSBLU and is the answer not in the manual?
Questions and answers