Alarm Input - Samsung SNB-7000 User Manual

setup screen
• Pre-alarm duration : Specify the time point before the occurrence of the alarm;
starting from the time point, the images will be transferred. You can specify up to
5 seconds before the occurrence of the alarm.
• Post-alarm duration : Specify the time point after the occurrence of the alarm; to
the specified time point, the images will be transferred. You can specify up to 120
seconds after the occurrence of the alarm.
4. When done, click [Apply (

Alarm input

You can set the alarm input type, activation time, and operation mode.
1. From the Setup menu, select the
<Event (
2. Click <Alarm input>.
3. Specify an input device.
• Type
- Normal Open : It is normally open,
but if it is closed, an alarm will be
triggered.
- Normal Close : It is normally
closed, but if it is open, an alarm
will be triggered.
4. Specify the <Activation time>.
• Always : Always check if an alarm occurs. It activates in operated mode when the
alarm occurs.

If set to Always, the activation time cannot be changed.
• Only scheduled time : Check if an alarm occurs at a specified day of the week for
a specified time period. It activates in operated mode when the alarm occurs.
• [
5. Specify an operation that will perform if an alarm occurs.
• Alarm output : Select whether to set the alarm output if an alarm is incoming, and
specify the alarm output time.
• E-mail sending : Specify the use of email transfer in the alarm input setup.
• FTP sending : Specify the use of FTP transfer in the alarm input setup.
• Record : Specify the use of recording in the alarm input setup.
• Goto Preset : Moves to the specified preset location when setting the alarm input.

Only if the camera pan/tilt receiver is installed, GoTo Preset is available.
6. When done, click [Apply (
66_ setup screen
)> tab.
] : Reset all settings.
)].
)].