Accumulation Period; Set Accumulation - Rainforest Automation EMU-2 User Manual

EMU-2™
User Manual
will be flashing. To change this digit, press the Top Button and cycle through the
numbers 0-9 until the desired value is displayed. Then press the Bottom Button to save
this digit. The next digit to the left will then be flashing. Repeat the process until all five
digits show the desired values. After the last digit is saved, your EMU-2™ will go to the
Billing Dates screen.

Accumulation Period

The Accumulation Period screen shows
Accumulation Period
the start and stop dates for the current
accumulation period that is displayed on
Start
the Total to Date screen. At the end of the
Set 
Jan 01
stop date, the accumulated data is
Skip 
transferred to the Previous Totals screen,
Stop
and the next accumulation period is
Jan 31
automatically started.
This screen can only be accessed in
Configuration Mode, after going through the Restart, Select Language, and Set Rate
screens.
The default billing period is a simple monthly cycle, beginning at 00:00:01 on the first
day of the month, and ending at midnight on the last day of the month. To change this
setting, press the Top Button to get to the Set Accumulation screen. Otherwise, press
the Bottom Button to go to the Battery screen.

Set Accumulation

The Set Accumulation screen allows you to
Set Accumulation
set the mode for the current accumulation
period displayed on the Total to Date
screen. There are 2 modes: "Monthly" uses
Change 
Enter Mode:
a simple calendar month for the
accumulation period; "Manual" allows you to
Keep 
Monthly
manually start and stop the accumulation
period.
The current mode setting is shown in the
lower left corner of the screen; it will be flashing. Press the Top Button to change the
mode. Press the Bottom Button to save the setting and exit back to the Accumulation
Period screen.
19