Rainforest Automation EMU-2 Quick Start Manual

YOUR EMU-2™ INFORMATION LABEL
Located on the back of your EMU-2™ is the Information Label that
identifies your individual device. You will need the two numbers
indicated below to register your device. Please make a note of them:
MAC Address (16 characters)
Install Code (16 characters)
TROUBLESHOOTING TIPS
●
Blank screen - unit Unplug power & remove batteries.
●
does not respond Wait 10 seconds.
to button press ●
Re-connect power; this will reset the unit.
●
Check display for signal strength. If weak signal, move unit
Unit has power but
closer to the meter for a stronger signal.
does not display
●
Move unit away from electronic devices that may interfere with
data
the signal (eg. wireless routers, cordless phones).
Display only says,
"Searching for
●
Contact your utility to provision your meter.
meters"
NEED HELP WITH YOUR EMU-2™?
For a full user manual, FAQs, and to contact support:
rainforestautomation.com/emu2_support
V2.1
WHAT'S IN THE BOX:
• EMU-2™ ENERGY DISPLAY
• AC POWER ADAPTER
• AAA BATTERIES (2)
Quick Start GUIDE
A new way to see your energy
rainforestautomation.com