Table of Contents
Advertisement
7. Maintaining and Cleaning the Light
There are NO user servicable internal parts, disassembly VOIDs the
warrantee and should NOT be attempted.
The light is a fixture of very low maintenance. It is only necessary to clean the air
inlets and outlets as well as the optical lenses from time to time. For safe operation it
is absolutely essential that the fixture is kept clean and that dust, dirt and smoke-fluid
residues must not build up on, or within the fixture. Otherwise the fixture's light-output
will be significantly reduced or damage can occur.
ensure the maximum light-output, but will also allow the fixture to operate reliably
throughout its life.
A soft lint-free cloth moistened with any good glass cleaning fluid is recom-
mended, under no circumstances should alcohol or solvents be used!
7.1. Safety regulations
1. Pull out the mains power
2. Wait min. 15 minutes after disconnecting power to allow the fixture to cool
down.
7.2.
Maintenance and Interval (rule-of-thumb)
The contamination of the fixture depends on the environment details. Hence no
general guidelines can be given. The intervals given below are only suggestions
from our experience.
Position
Optical System
Fan & Air Channels
Attention:
1 Never let optical parts come into contact with oil or fat.
2 Before running the fixture wait until all parts are dry.
3 Never touch lenses with bare fingers.
plug!
Interval
Weekley
Monthly
Regular cleaning will not only
Maintenance
Soft Brush / Lint-free cloth
Vacuum Cleaner, Airbrush etc
17
Advertisement
Table of Contents
