Table of Contents
Advertisement
Base Search flashes in the display.
The handset is set to
Best Base
tion is switched on or within range.
¥
Move the handset closer to the base station.
¥
Check the base station's mains adapter
(page 7).
Handset does not ring.
1. The ringer tone is switched off.
¥
Activate the ringer tone (page 44).
2. Call diversion set to
¥
Switch off call diversion (page 18).
You cannot hear a ringer/dialling tone from
the fixed network.
The phone cord supplied has not been used or
has been replaced by a new cord with the
wrong jack connections.
¥
Please always use the phone cord supplied
or ensure that the jack connections are cor-
rect when purchasing from a retailer
(page 7).
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Reset the system PIN to 0000 (page 51).
Forgetting the system PIN.
¥
Reset the system PIN to 0000 (page 51).
Call charges are not displayed.
1. Your network provider does not support this
feature.
2. There are no metering pulses.
¥
Ask your network provider to transmit
the metering pulses.
The other party cannot hear you.
u
You have pressed the
set is "muted".
¥
Switch on the microphone again (page 17).
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
¥
The caller should ask the network provider
to release Calling Line Identification (CLI).
and no base sta-
All
Calls.
(INT) key. The hand-
You hear an error tone when keying an input
(a descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user
guide if necessary.
You cannot listen to messages on the net-
work mailbox.
Your phone system is set for pulse dialling.
¥
Set your phone system to tone dialling.
Appendix
55
Hide quick links:
Advertisement
Table of Contents
