Cashinotech CSN-A2 User Manual page 8

CSN-A2 Micro panel thermal printer
Chapter4 Chapter4 Using Using
Chapter4 Chapter4 Using Using attention
4.1 Please notice, the ESD wrist ring and the humidity manufactures ETC, when using
the printer,to protect the inner electronic parts of the printer from the damage of
ESD,because the TPH of the Printer and photoelectric sensor are ESD Sensitive
parts.
4.2 For protecting plastic shaft,Don't smear any oil or others on the rubber parts
4.3 Don't touch the TPH, TPH having the palm oil,will induce the usage of the printer.If
any oil or others in the TPH,please using an alcohol cotton stick clean the area
between plastic shaft and printer head at once.PS,Don't strike the TPH.
4.4 Due to the printer is easy-paper structure,you need pick up the rubber stick only
push the rubber stick.So,if the paper jam,push harder will cause the rubber stick
gearwheel damaged.so please don't push the paper harder,please do open the cover
and re-fill the paper.
4.5 The temperature of the TPH protection must be below 65 ℃ ,if you print
continuously,Because the exterior of the temperature of the IC protection & motor
can't not over 90℃ to protect the motor thread ring.
4.6 Please use the good quality paper,because the sensitive of the paper will
influence print effect,meanwhile,rough paper will increase the excessive wear to the
printer head, and reduce the life of the printer.
attention attention
attention
8/26