Cashinotech CSN-A2 User Manual page 23

CSN-A2 Micro panel thermal printer
Description: Setting the time for control board to enter sleep mode.
n1 = 0-255 The time waiting for sleep after printing
finished,Unit(Second),Default:0(don't sleep)
When control board is in sleep mode, host must send one byte(0xff)
to wake up control board. And waiting 50ms, then send printing
command and data.
NOTE:The command is useful when the system is powered by
battery.
DC2 DC2 DC2 # # # # n n n n
DC2 Set printing density
Format:
Description：
D4..D0 of n is used to set the printing density
Density is 50% + 5% * n(D4-D0)
D7..D5 of n is used to set the printing break time
DC2 DC2 DC2 DC2 E E E E Feed paper to mark
Format:
Description: Feed paper to the Mark position
DC2 DC2 DC2 m m m m d d d d 1l 1l 1l 1l 1h 1h 1h
DC2 1h Set mark paper length
Format:
Description：
d = 0,1
0 ≤ ll ≤ 255
0 ≤ lh ≤ 255
Paper length is (ll+lh*256) steps,means (ll+lh*256)/8 mm
DC2 DC2 T T T T
DC2 DC2 Printing test page
Format:
Description：
Printing the test page
ASCII: DC2 # n
Decimal: 18 35 n
Hexadecimal: 12 23 n
Break time is n(D7-D5)*250us
ASCII: DC2 E
Decimal: 18 69
Hexadecimal: 12 45
ASCII: DC2 m d 1l 1h
Decimal: 18 109 d 1l 1h
Hexadecimal: 12 6d d 1l 1h
1:stop at mark position
0:go on 3 steps after mark position detected
ASCII: DC2 T
Decimal: 18 84
Hexadecimal: 12 54
23/26